Wagan AC Inverter Manual do Utilizador

3,000 Watt AC InverterProLine ™User’s ManualItem No. #2007-2 (12V)#2007-4 (24V)#2007- 8 (48V)ProLine™ 3,000 Watt DC to AC Power Inverter

BATTERY BANK DIAGRAMThe diagrams below show inverter connections to a battery bank with recommended fuse protection. Safety Ground#2007-212V220Ah++––1

FUSING REQUIREMENTSNOTE: It is important that this 3,000 watt inverter has the correct main battery fuse added to the Positive (+) battery cable as cl

Procedure1. Connect the Negative (−) cable ring terminal to the Negative (−) Battery Terminal.2. Install the ANL fuse in the Fuse holder Positive (+

10. When the voltage reading does not fall within this range, check the connections of the wires to the terminals on the battery bank and the inverter

WARNINGTHERE IS DANGER OF AN EXPLOSION. DO NOT CONNECT OR DISCONNECT CHARGER CABLES DIRECTLY AFTER BATTERY DISCHARGE OR RECHARGE— MAKE SURE THAT THE B

PROBLEM: Inverter shutdownReason SolutionBattery voltage below rated value. (Code E03)Recharge or replace battery.Equipment being operated draws too m

Name DescriptionOutput Waveform Modified Sine WaveformTrueRated Power™3,000 watts continuousSurge Power 6,000 wattsEfficiency Approximately 90%No load

The WAGAN Corp. warranty is limited to products sold only in the United States.All Wagan Tech products must be registered within (30) days of purchase

31088 San Clemente Street Hayward, CA 94544, U.S.A. Tel: + 1.510.471.9221 U.S. & Canada Toll Free: 1.800.231.5806 [email protected] www.wa

Thank you for purchasing the ProLine™ 3,000W Power Inverter by Wagan Tech®. With minimal care and proper treatment it will provide years of reliable s

will automatically shut down in the event of an output overload, so there is no danger of damaging either the inverter or the equipment.This inverter

readout to the next readout. The lit/unlit status of two green LEDs show which function is being shown on the Digital DisplayThe display and button ar

Watts Readout – Digital Display (both left LED and right LED lit) The Watts readout shows AC watts delivered to the connected operating AC appliance l

about 20 to 30 volts too low. Any multi-meter identified as “TRUE RMS” will accurately read MSW correctly.Modified Sine Wave (MSW) Pure Sine WaveREAR PA

Ground TerminalThis connection is located on the lower left of the rear panel. It is for attaching a 6 gauge insulated safety ground wire. This safety

2. Estimate the number of hours the appliances will be in use between battery recharges. This will vary depending on appliances. For example, a typic

The left vertical numbers of the curve represents percentage of the battery capacity at the 20 hour rate. In this example, the user needs a one hour r